Camping air bed: choosing and caring for your sleep setup
A camping air bed can be a comfortable option when travelling by car and you prefer a soft sleeping surface raised off the ground. Its thick mattress can feel familiar and make getting in and out of bed easier. Without suitable insulation, however, an air bed can feel surprisingly cold as air circulates inside it.
A little preparation can make camping more comfortable. Add suitable accessories to your camping gear checklist to help prevent a cold night and care for your sleeping equipment.
Dealing with cold from the ground
A conventional air bed has no insulating material inside. The air in it can cool with the ground and surrounding air, allowing body heat to escape through the mattress.
These measures can make your sleeping setup warmer:
- Put an insulating layer underneath: Place an aluminium picnic blanket or a thin foam mat with reflective foil on the groundsheet beneath the air bed.
- Add a thick blanket on top: Put a wool or fleece blanket directly over the velour surface, underneath your fitted sheet or sleeping bag, to provide a warm layer between you and the air inside.
- Use a flannel fitted sheet: Flannel feels warm when you get into bed, unlike smooth cotton or cold polyester.
Choosing an air bed: single or double?
A double air bed may seem appealing, but it can have practical drawbacks in a tent. When one person turns over, the whole mattress can move. If it is not inflated firmly, the lighter person may also roll towards the middle. Two single beds placed together and secured with a joining strap or a shared double fitted sheet can reduce disturbance.
Consider the height as well:
- Low air beds, around 20 cm: These take up less space in the tent, leaving more room beneath sloping walls.
- High air beds, 40 cm or more: These can make getting up easier, but need a spacious family tent with straight walls.
Inflating and maintaining the right firmness
Avoid inflating an air bed rock hard on a warm afternoon. Air expands when warm and contracts as the temperature falls.
Inflate the bed to around 90 percent of its capacity. It should give a little when you press the middle with your hand. Overinflation puts pressure on the welded seams and can cause small splits along the edges.
If the bed feels softer during the night, cooling air may be the reason rather than a leak. Add a little air with a hand pump before bed if needed.
Cleaning and safe storage
Careful handling helps an air bed last:
- Clean the velour surface: Remove dust and sand with a soft brush or vacuum cleaner. Wipe marks with a slightly damp cloth and a little neutral soap. Let the surface dry completely before folding.
- Avoid sharp objects: Check that there are no pine cones or sharp branches beneath the groundsheet. An extra groundsheet under the inner tent may help.
- Store away from frost: After the season, roll the bed loosely with the valve open. Keep it in a dry place at room temperature, since extreme cold can make PVC stiff and brittle.
Camping air bed FAQ
Why does my air bed slowly lose air when there is no visible leak?
Check the valve first. Sand or dust caught in the rubber seal can allow air to escape slowly. Clean the valve and make sure the cap is firmly closed.
How do I repair a hole in the soft velour top?
Gently sand away the velour fibres around the hole with fine sandpaper until the smooth PVC is exposed. Clean the surface with alcohol, apply a drop of flexible PVC adhesive and press the repair patch firmly over it.
Which pump is practical for camping?
A rechargeable pump or one powered by a 12-volt car socket is convenient for large beds. A compact double-action hand pump is useful as a backup and for adjusting firmness inside the tent.